Pyle PSR14 User Manual

To set the time on the Pyle PSR14, press and hold the 'Time Set' button until the display starts flashing. Use the 'Hour' and 'Minute' buttons to adjust the time. Press 'Time Set' again to confirm.
Press the 'Alarm Set' button and hold it until the display flashes. Adjust the hour and minute using the corresponding buttons. Press 'Alarm Set' again to finalize the alarm time.
Ensure the clock is plugged in properly and the backup battery is not depleted. Reset the time as per the instructions in the manual. Replace the battery if necessary.
Press and hold the '12/24 Hour' button until the display changes. Release the button to set your preferred time format.
Check if the alarm is turned on by ensuring the alarm indicator is displayed. Verify the alarm time settings and make sure the volume is set high enough to hear.
When the alarm sounds, press the 'Snooze' button to delay the alarm for a few minutes. The snooze duration is preset and typically lasts around 9 minutes.
The backup battery ensures that the clock retains time settings during power outages. Replace it by opening the battery compartment, removing the old battery, and inserting a new one of the same type, ensuring correct polarity.
Press the 'Display' button repeatedly to cycle through the brightness settings until you reach your desired level.
Yes, the Pyle PSR14 has a built-in radio. Use the 'Radio' button to turn it on and the 'Tuning' buttons to find your desired station.
Ensure the antenna is fully extended and try repositioning the unit to improve reception. If the problem persists, consider moving the clock to a different location with better signal strength.