Midea MRQ22D7AST Energy Guide
![Midea MRQ22D7AST Refrigerator manual cover](/images/IJesavHouzgfNPWPrPJgeXUJ/thumbs/thumb175x175.webp)
To adjust the temperature, press the 'Temp' button on the control panel. You can toggle between the fridge and freezer settings and adjust to your desired temperature using the '+' or '-' buttons.
Ensure the refrigerator is plugged in and the power is on. Check if the vents are blocked by food items. Clean the condenser coils and ensure the temperature settings are correct. If the problem persists, contact Midea customer service.
It is recommended to clean the condenser coils every 6 to 12 months to ensure optimal performance and energy efficiency.
Store raw meats on the lower shelves to prevent contamination. Use the door compartments for condiments and drinks, and keep fruits and vegetables in the designated crisper drawers.
First, ensure the water supply is connected and turned on. Check the water filter and replace it if necessary. Inspect the dispenser for any blockages or airlocks.
Unusual noises could be due to the refrigerator not being level or items vibrating inside. Ensure the unit is on a flat surface and rearrange items inside. Check for loose parts or debris around the compressor area.
The refrigerator is equipped with an automatic defrost feature. However, if manual defrosting is needed, remove all food, unplug the unit, and leave the doors open. Once defrosted, clean and dry the interior before plugging it back in.
Locate the water filter compartment inside the refrigerator. Turn the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it is secure. Run water through the dispenser for a few minutes to clear any air.
Ensure the ice maker is turned on and the water supply is connected. Check for any ice blockages in the ice tray or chute. If necessary, reset the ice maker following the instructions in the user manual.
To perform a factory reset, locate the reset button on the control panel, usually marked with a small circle or triangle. Press and hold the button for 10 seconds until the display flashes. This will reset the settings to default.