McCulloch M56-190APX 4x4 Spare Parts List
![McCulloch M56-190APX 4x4 manual cover](/images/zIwwWJkDCYKMmfYouHZccbME/thumbs/thumb175x175.webp)
To start the McCulloch M56-190APX 4x4 Lawn Mower, ensure the fuel tank is filled and the oil level is adequate. Set the throttle to the start position, engage the choke if the engine is cold, and pull the starter handle briskly.
If the mower does not start, check the fuel level, ensure the spark plug is connected, inspect the air filter for blockages, and verify the choke is engaged if the engine is cold.
Regularly check the blades for damage and sharpness. Sharpen the blades as needed, and replace them if they are bent or excessively worn. Always disconnect the spark plug before performing maintenance on the blades.
The recommended oil type for the McCulloch M56-190APX 4x4 Lawn Mower is SAE 30 or 10W-30, depending on the ambient temperature. Refer to the user manual for specific recommendations.
The air filter should be checked before each mowing session. Clean it every 25 hours of use or more often in dusty conditions. Replace the air filter if it is excessively dirty or damaged.
Excessive vibration can be caused by unbalanced blades or loose components. Inspect the blades for damage, ensure all bolts and nuts are tight, and check for debris buildup under the deck.
To adjust the cutting height, locate the height adjustment levers on each wheel. Move the levers to the desired position, ensuring all wheels are set at the same height for an even cut.
Uncut patches can be due to dull blades, incorrect cutting height, or mowing too quickly. Sharpen the blades, adjust the height, and mow at a steady pace to ensure an even cut.
To clean the underside of the mower deck, ensure the engine is off and the spark plug is disconnected. Tilt the mower on its side and use a brush or scraper to remove grass clippings and debris. Avoid using water to prevent rust.
For off-season storage, clean the mower thoroughly, remove fuel or add a stabilizer, change the oil, and store it in a dry, covered area. Disconnect the spark plug and remove the battery if applicable.