McCulloch M46-625 CDW Spare Parts List
![McCulloch M46-625 CDW manual cover](/images/LKFdaXioGHoVdFynSGGGIbVb/thumbs/thumb175x175.webp)
To start the McCulloch M46-625 CDW, ensure the fuel tank is filled, the oil level is adequate, and the spark plug is connected. Pull the starter cord firmly while holding the handlebar lever.
Check the fuel level and quality, ensure the spark plug is clean and connected, and verify that the air filter is not clogged. Replace any faulty components as needed.
The blades should be sharpened after approximately 25 hours of use or at the start of each mowing season to ensure optimal performance.
SAE 30 oil is recommended for the McCulloch M46-625 CDW, especially in temperatures above 40°F (4°C). For colder conditions, consider using SAE 10W-30.
After use, disconnect the spark plug and use a brush or cloth to remove grass clippings and debris. For a thorough clean, use a hose to rinse the underside of the deck, avoiding water contact with the engine.
Uneven cutting may result from dull blades, incorrect mowing height, or clogged discharge chute. Ensure blades are sharp, adjust the mowing height, and clear any obstructions.
To adjust the cutting height, use the lever located near the wheels. Move the lever to the desired position to set the appropriate cutting height.
During the off-season, clean the mower thoroughly, change the oil, remove the spark plug, and store the mower in a dry location. Consider adding a fuel stabilizer to the gasoline.
To replace the air filter, remove the filter cover, take out the old filter, and insert a new one. Ensure the filter is installed correctly and the cover is securely fastened.
Excessive vibration may be caused by an unbalanced blade or loose parts. Check that the blade is properly balanced and inspect for any loose components, tightening them as necessary.