Logik LNF55S17 Instruction Manual

To adjust the temperature, locate the thermostat dial inside the refrigerator. Turn the dial clockwise to lower the temperature and counterclockwise to raise it. Allow 24 hours for the new setting to stabilize.
Check if the refrigerator is plugged in and the thermostat is set correctly. Ensure the vents inside the fridge are not blocked. If the issue persists, inspect the door seals for damage or gaps and clean the condenser coils.
Defrost the freezer whenever the frost build-up reaches about 0.5 cm (0.2 inches) thick. This helps maintain efficient cooling and energy usage.
Unusual noises can be caused by a variety of factors including the compressor, fan, or ice build-up. Ensure the fridge is level and not touching any walls or cabinets. If noises persist, consult the user manual or contact customer support.
Unplug the refrigerator and locate the condenser coils, usually at the back or underneath the unit. Use a vacuum cleaner or a coil brush to remove dust and debris. Clean the coils every six months for optimal performance.
Store raw meat on the bottom shelf to prevent drips onto other foods. Keep fruits and vegetables in the crisper drawers, and place dairy products in the coldest part of the fridge. Avoid overloading the shelves to ensure proper air circulation.
Ensure the door seals are intact and clean. Keep the refrigerator away from heat sources and direct sunlight. Regularly defrost the freezer and maintain a stable temperature setting. Avoid frequent door openings.
Check if the defrost drain is clogged and clean it if necessary. Ensure the refrigerator is level and inspect the door seals for any gaps. If the problem continues, consult a technician.
Inspect the door seals for dirt or damage and clean them if needed. Ensure that food items are not obstructing the door. If the door is misaligned, adjust the hinges according to the manual instructions.
Unplug the refrigerator and locate the light cover inside the fridge. Remove the cover and unscrew the old bulb. Replace it with a new bulb of the same type and wattage, then reattach the cover.