Logik LFC60W12 Instruction Manual

To adjust the temperature, locate the thermostat dial inside the fridge compartment. Turn the dial clockwise to decrease the temperature and counterclockwise to increase it. Allow 24 hours for the temperature to stabilize after adjustment.
Check if the appliance is plugged in and the thermostat is set correctly. Ensure the door seals are clean and intact. Avoid overloading the fridge, and ensure there is adequate space around the refrigerator for ventilation.
The Logik LFC60W12 is typically self-defrosting. However, if frost builds up excessively, manually defrost it by turning off the fridge and leaving the door open until the ice melts. Clean up the water and restart the refrigerator.
Turn off and unplug the refrigerator. Remove all food and shelves. Use a mixture of warm water and baking soda to wipe down the interior surfaces. Rinse with a clean, damp cloth and dry thoroughly before replacing shelves and food.
The ideal temperature for the fridge compartment is between 3°C and 5°C (37°F and 41°F), while the freezer should be set to -18°C (0°F) for optimal food preservation.
Unusual noises can be due to the refrigerator being unlevel, items inside vibrating against each other, or normal operation sounds like the compressor cycling. Check for any loose items and ensure the appliance is stable.
Unplug the refrigerator. Locate the light cover inside the fridge, remove it by unscrewing or unclipping it, and replace the bulb with a new one of the same type and wattage. Reattach the cover and plug the appliance back in.
Empty the refrigerator, unplug it, clean and dry the interior, and leave the door slightly ajar to prevent odors and mold. Consider using a moisture absorber inside the fridge.
Ensure the door seals are tight, keep the fridge away from heat sources, avoid frequent opening of the doors, and ensure proper ventilation around the appliance. Regularly defrost if necessary to maintain efficiency.
Inspect the door gasket for any debris or damage. Clean it with warm soapy water and dry thoroughly. If the gasket is damaged, it may need to be replaced to ensure a proper seal.