Logik LF674SSN Instruction Manual
![Logik LF674SSN manual cover](/images/auXVwTHgFnHbRpGphbMZwezw/thumbs/thumb175x175.webp)
To start a wash cycle, load your dishwasher, add detergent, close the door securely, select your desired program using the control panel, and press the start button.
Check for clogs in the drain hose or filter. Ensure the drain hose is not kinked and the filter is clean. If the issue persists, inspect the drain pump for obstructions.
Remove the lower dish rack, unscrew the cylindrical filter unit at the bottom of the dishwasher, and clean it under running water. Reassemble the filter before using the dishwasher again.
Error code E4 indicates a water overflow error. Check if the dishwasher is overfilled and ensure that the water inlet valve is functioning properly.
It is recommended to clean the spray arms every few months or if you notice a decrease in cleaning performance. Remove them and rinse under water to clear any blockages.
Yes, you can use rinse aid. To add it, open the rinse aid dispenser located on the inside of the door, fill it with rinse aid, and close the dispenser cap securely.
Ensure that you are using a rinse aid to improve drying performance. Check that the selected wash cycle includes a drying phase and that the dishwasher is not overloaded.
Ensure dishes are loaded properly without obstructing spray arms, use the correct amount of detergent, and regularly clean the filter and spray arms to prevent blockages.
Regularly clean the filter, check and clean the spray arms, inspect the door seals for debris, and run an empty cycle with a dishwasher cleaner to remove buildup.
Check the door seal for damage or debris, ensure the dishwasher is level, inspect hoses for leaks, and verify that the soap dispenser is not blocked or overfilled.