Logik LCRAD14 Instruction Manual
![Logik LCRAD14 manual cover](/images/cNJfwivFbXjeTgnUuyHkNtKo/thumbs/thumb175x175.webp)
To set the time, press the 'Time Set' button and use the tuning knob to adjust the hours and minutes. Confirm each setting by pressing the 'Time Set' button again.
Ensure the radio is plugged into a working power outlet. Check the power cord for any damage. If using batteries, replace them with a new set.
Extend the antenna fully and adjust its position. Place the radio near a window and away from electronic devices that may cause interference.
Tune to the desired station, then press and hold a preset button (1-5) until you hear a beep. The station is now saved to that preset button.
Use a soft, dry cloth to wipe the exterior. Avoid using water or cleaning agents on the radio. For stubborn spots, a slightly dampened cloth may be used.
Check the volume level to ensure it is turned up. Verify that headphones are not plugged in. If using external speakers, ensure they are properly connected.
Press the 'Band' button on the radio to toggle between AM and FM modes. The display will indicate the current band.
Check the power supply and ensure the radio is receiving power. If the problem persists, a reset might be needed. Refer to the manual for reset instructions.
Locate the reset button on the back of the radio. Press and hold it for 10 seconds using a pointed object, such as a paperclip, until the radio resets.
Press the 'Sleep' button repeatedly to cycle through the available sleep times (15, 30, 45, 60, 90 minutes). The radio will automatically turn off after the set time.