Logik L712WM13 Instruction Manual

To start a wash cycle, turn on the machine, load your laundry, add detergent, select the desired program using the program selector dial, and press the start/pause button.
Check if the drain hose is kinked or blocked. Ensure the pump filter is clean. If the problem persists, consult the user manual or contact a professional technician.
Remove the detergent drawer by pulling it out and pressing the release lever. Wash it under warm water to remove any residue. Reinsert the drawer after cleaning.
Regularly clean the detergent drawer, drum, and door seal. Check and clean the filter monthly. Ensure the machine is level to avoid excessive vibrations.
Ensure the machine is level on the floor. Check if the transit bolts have been removed. Also, make sure the load is balanced inside the drum.
Check if the machine is plugged in and switched on. Ensure the door is closed properly. Verify that the water supply is turned on. If needed, reset the machine by unplugging it for a few minutes.
Run an empty wash cycle with a cup of white vinegar or a washing machine cleaner to eliminate odors. Clean the door seal and leave the door open after each wash to allow the drum to dry.
Turn the program selector dial to the quick wash option. Adjust the temperature and spin speed if necessary, and press the start/pause button to begin the cycle.
Press the start/pause button to pause the cycle. If you wish to cancel the cycle entirely, turn the program selector dial to the 'Off' position.
Refer to the user manual for a detailed explanation of each error code. Common codes indicate issues such as water supply problems, drainage issues, or door lock faults.