Logik L22DAB10 Instruction Manual
![Logik L22DAB10 manual cover](/images/SgLyNPTulTJBHMitoIPctAvm/thumbs/thumb175x175.webp)
To set the alarm, press the 'Alarm' button on the radio, use the 'Tune/Select' knob to set the desired time, and confirm by pressing the 'Select' button. Make sure the radio is set to the correct time beforehand.
Check if the radio is properly plugged into a power source. If it’s using batteries, make sure they are inserted correctly and have sufficient charge. Try resetting the radio by unplugging and plugging it back in.
Extend the antenna fully and try repositioning the radio near a window or higher up. Avoid placing it near electronic devices that might cause interference.
To perform a factory reset, press and hold the 'Menu' button, navigate to 'System' settings, choose 'Factory Reset', and confirm the selection. This will erase all presets and settings.
Ensure the radio is receiving power. If the problem persists, try resetting the radio. If the issue is not resolved, the display may need professional repair.
Tune to the desired station, then press and hold one of the preset buttons until the display confirms the station is saved. Repeat for other stations as needed.
Check if the volume is turned up and ensure the mute function is not activated. Verify that headphones are not plugged in, which would redirect the sound.
Yes, the radio has a headphone jack located on the side or front panel. Simply plug in your headphones to listen privately.
Press the 'Mode' button on the radio to toggle between FM and DAB modes. The current mode will be displayed on the screen.
This indicates that the radio is unable to find any DAB stations. Try repositioning the antenna and ensure you are in an area with DAB coverage. Perform a full scan to search for available stations.