Klarstein BROOKLYN 10035223 User Manual

To set up the Klarstein BROOKLYN 10035223 Refrigerator, place it on a flat, stable surface away from direct sunlight and heat sources. Allow at least 10 cm of space around the sides and back for proper ventilation. Plug it into a grounded electrical outlet. Let it run for a few hours before adding any food.
First, check if the door is fully closed and the seal is intact. Ensure the temperature control is set to the desired level. Verify that the refrigerator is away from heat sources and that there is adequate ventilation around it. If the problem persists, consider defrosting the fridge or contacting customer service.
The refrigerator should be defrosted whenever the frost build-up reaches about 3-5 mm thick. This helps maintain efficiency and cooling performance.
To clean the interior, unplug the refrigerator and remove all food items. Use a solution of mild detergent and warm water to wipe the shelves and interior surfaces. Rinse with clean water and dry with a soft cloth before restocking the refrigerator.
Pooling water can result from a clogged defrost drain. Unplug the refrigerator and locate the drain hole, typically at the back or bottom. Use a pipe cleaner or a small brush to clear any blockages.
Unusual noises could be due to the refrigerator being unlevel, items inside vibrating, or the compressor starting. Ensure the fridge is on a level surface and evenly distribute items inside. If the noise persists, consult the user manual or contact customer support.
Locate the temperature control dial inside the refrigerator, usually at the rear or on the side. Turn the dial to adjust the temperature; higher numbers typically indicate colder settings.
It is not recommended to store hot food directly in the refrigerator as it can raise the internal temperature and affect other stored items. Allow hot food to cool to room temperature before refrigerating.
Unplug the refrigerator before replacing the bulb. Remove the light cover inside the fridge, unscrew the old bulb, and replace it with a new bulb of the same type and wattage. Reattach the light cover and plug the refrigerator back in.
Routinely check and clean the door seals to ensure they are tight and free from debris. Defrost the refrigerator as needed, clean the interior regularly, and ensure proper ventilation around the unit. Periodically move the fridge to clean the condenser coils at the back.