Honda Crosstour 2013 Navigation Manual
![Honda Crosstour 2013 manual cover](/images/97c6490736cd134885b65de4/thumbs/thumb175x175.webp)
To reset the oil maintenance light, turn the ignition to the "ON" position without starting the engine. Press the "Select/Reset" button until the oil life indicator is displayed. Press and hold the "Select/Reset" button for about 10 seconds until the indicator begins to blink. Release the button, then press and hold it again for 5 seconds until the oil life resets to 100%.
Honda recommends using SAE 0W-20 full synthetic motor oil for the 2013 Crosstour to ensure optimal performance and efficiency.
To improve fuel efficiency, ensure regular maintenance such as timely oil changes and air filter replacements. Keep your tires properly inflated, drive at steady speeds, and avoid excessive idling. Removing unnecessary weight from the vehicle can also help.
The 2013 Honda Crosstour has a towing capacity of up to 1,500 pounds when properly equipped. Always refer to the owner's manual for specific towing guidelines and ensure the vehicle is prepared for towing.
To pair your phone, turn on the vehicle and enable Bluetooth on your phone. On the Crosstour's infotainment system, select "Phone" and then "Bluetooth Setup." Choose "Add Bluetooth Device" and select your phone from the list. Follow the prompts to complete the pairing process.
Common causes for the "Check Engine" light include a loose gas cap, faulty oxygen sensor, malfunctioning catalytic converter, or issues with the ignition system. It's advisable to have the vehicle scanned for error codes to diagnose the specific issue.
Open the glove compartment and remove the damper on the right side. Press in the sides of the glove box to release it. Locate the cabin air filter cover, unclip it, and remove the old filter. Insert the new filter with the airflow direction arrow pointing down. Reassemble the glove compartment.
The recommended tire pressure for a 2013 Honda Crosstour is 32 psi for both front and rear tires. Always check the tire pressure when the tires are cold for an accurate reading.
Honda recommends checking the transmission fluid regularly and replacing it every 30,000 to 60,000 miles, depending on driving conditions. Consult the owner's manual for specific intervals and recommendations.
To jump-start the Crosstour, first park a working vehicle close to the Crosstour without the vehicles touching. Turn off both engines and connect the jumper cables in this order: positive cable to the Crosstour's positive terminal, positive cable to the donor vehicle's positive terminal, negative cable to the donor vehicle's negative terminal, and finally, attach the negative cable to an unpainted metal surface on the Crosstour. Start the donor vehicle and then the Crosstour. Once started, remove cables in reverse order.