Frigidaire FGEW3069UF Quick Start Guide
![Frigidaire FGEW3069UF manual cover](/images/aa3a639437be529e6a8ba794/thumbs/thumb175x175.webp)
To perform a self-clean cycle, remove all racks and accessories from the oven. Close the oven door and press the 'Self Clean' button. Select the desired cleaning duration using the arrow keys, then press 'Start'. The door will lock automatically during the cycle.
If an error code appears, first try resetting the oven by turning off the circuit breaker for a few minutes. If the error persists, consult the user manual for specific error code troubleshooting steps or contact Frigidaire customer service.
To adjust the oven temperature calibration, press and hold the 'Bake' button for six seconds until the display shows '0'. Use the arrow keys to adjust the temperature up or down, then press 'Start' to save the changes.
To clean the oven racks, remove them from the oven and soak them in warm, soapy water. Use a non-abrasive scrubber to remove any residue. Rinse and dry thoroughly before placing them back in the oven.
To replace the oven light bulb, ensure the oven is cool and the power is off. Remove the glass light cover by turning it counterclockwise. Replace the bulb with a new 40-watt appliance bulb, then reattach the light cover.
If the oven isn't heating properly, check if the heating elements are working. Ensure there's no error code on the display. If the issue persists, the temperature sensor might be faulty, and professional service may be required.
It is safe to use aluminum foil to line the drip pans and baking sheets. However, avoid covering the oven floor or racks, as this can block airflow and affect cooking performance.
To set the delay start, press the 'Bake' button and set the desired temperature. Press 'Cook Time' and enter the cooking duration. Then press 'Delay Start' and enter the start time. Press 'Start' to activate the delay start feature.
Regularly clean the oven interior and exterior surfaces. Check and clean the door gasket to ensure a good seal. Inspect the heating elements for signs of wear or damage. Perform a self-clean cycle as needed.
To lock the oven controls, press and hold the 'Lock' button for three seconds. The control panel will be disabled, and the display will show 'Loc'. To unlock, press and hold the 'Lock' button again for three seconds.