Fagor FT-6413S User Manual
![Fagor FT-6413S Washing Machine manual cover](/images/XstLiYfZDkKnAPEHYFELAKtH/thumbs/thumb175x175.webp)
To start a wash cycle, first load your laundry into the drum. Add the appropriate amount of detergent in the detergent compartment. Select the desired wash program using the program selector dial, then press the start/pause button to begin the wash cycle.
Ensure that the machine is properly plugged into a functioning power outlet. Check that the door is firmly closed, as the machine will not start if the door is open. Verify that the water supply is turned on. If the issue persists, check the circuit breaker and refer to the user manual for further troubleshooting steps.
To clean the detergent drawer, pull it out gently until it stops, then press down on the release lever to remove it completely. Wash the drawer under running water to remove any detergent residue. Dry it thoroughly before placing it back into the machine.
Regularly clean the detergent drawer, drum, and door seal to prevent mold build-up. Check and clean the filter located at the bottom of the machine monthly. Run an empty hot wash cycle with a cup of white vinegar once a month to clean the drum and eliminate odors.
Ensure that the drain hose is not kinked or blocked. Check the filter for obstructions and clean it if necessary. Make sure the drain pump is functioning correctly. If the problem persists, consult a professional technician.
Yes, you can pause the wash cycle by pressing the start/pause button. Wait for a few seconds until the door unlocks, then add the clothes. Close the door securely and press the start/pause button again to resume the cycle.
Ensure that the washing machine is level by adjusting the feet. Avoid overloading the drum and distribute clothes evenly. Check for any loose objects in pockets that may cause noise. Use the correct spin speed for the fabric type.
Run a cleaning cycle using hot water and a cup of white vinegar to remove any mold or detergent build-up. Leave the door open after each wash to allow the interior to dry. Regularly clean the door seal and detergent drawer.
To reset the washing machine, unplug it from the power source for a few minutes. Plug it back in and turn it on. This should reset the machine's electronics. If problems persist, refer to the user manual or contact customer support.
Common error codes include E1 (water supply issue), E2 (drainage problem), and E3 (door not closed). Each code indicates a specific problem; consult the user manual for detailed troubleshooting steps corresponding to each error code.