Currys Essentials CDWTT15 Instruction Manual
![Currys Essentials CDWTT15 manual cover](/images/lJKprCyaGBgwxrtXqrUiNpWX/thumbs/thumb175x175.webp)
To reset your Currys Essentials CDWTT15 Dishwasher, press and hold the start button for about 3 seconds until the control panel lights turn off. Release the button to initiate the reset process.
If your dishwasher is not draining, check for blockages in the drain hose, filter, and pump. Clean out any debris and ensure the hose is not kinked. If the issue persists, consult the user manual or contact customer support.
Spots on dishes may be due to hard water. Use a rinse aid to help eliminate spots and ensure you are using the correct amount of detergent. Check that the water temperature is set to at least 120°F (49°C) for optimal cleaning.
It is recommended to clean the filter once a month to ensure optimal performance. Remove the filter, rinse it under running water, and use a soft brush to remove any stubborn debris.
If your dishwasher is noisy, check for items blocking the spray arms and ensure dishes are loaded correctly. Inspect the pump and motor for any obstructions. If the noise continues, it may require professional servicing.
No, you should not use regular dish soap in your dishwasher. It can cause excessive suds and potentially damage the appliance. Use only dishwasher-specific detergents.
To improve drying performance, ensure you are using rinse aid and selecting a drying cycle. Check that the water heater is functioning properly and that the dishwasher door is opened slightly after the cycle to allow steam to escape.
Error code E4 typically indicates a water overflow issue. Check for leaks or blockages in the water inlet valve and ensure that the float switch is functioning correctly. If necessary, refer to the manual or contact a technician.
A bad odor can result from food debris or grease build-up. Regularly clean the filter, spray arms, and door seals. Running a cycle with vinegar or a dishwasher cleaner can also help eliminate odors.
To adjust the water hardness setting, consult the user manual for specific instructions. Typically, this involves accessing the settings menu via the control panel and selecting the appropriate hardness level based on your local water supply.