Bush DAB30 Instruction Manual
![Bush DAB30 Radio manual cover](/images/DkFloyIatIxtbEcijgfyeiaK/thumbs/thumb175x175.webp)
To perform a factory reset on your Bush DAB30 Radio, press and hold the 'Menu' button until the menu appears. Use the tuning control to select 'Factory Reset' and confirm your choice by pressing the 'Select' button.
Ensure that the radio is properly connected to a power source and the power cable is not damaged. Check the power switch and try a different outlet if necessary.
Extend the radio's antenna fully and position it for optimal reception. Avoid placing the radio near electronic devices that may cause interference, and try moving it closer to a window.
Check the antenna connection and ensure it is fully extended. Try performing a scan for stations by accessing the menu and selecting 'Auto Tune'.
Press the 'Menu' button, navigate to the 'Alarm' option using the tuning control, and press 'Select'. Set the desired alarm time and settings, then confirm by pressing 'Select' again.
Ensure the volume is not set too high and check that the speakers are not obstructed. Additionally, verify that the radio is tuned to a strong signal.
Tune to the desired station, then press and hold a preset button until you hear a beep. The station is now saved to that preset button.
Yes, the Bush DAB30 Radio has a headphone jack. Simply plug in your headphones to listen privately.
Press the 'Menu' button and select 'Time Setup'. Use the tuning control to adjust the hours and minutes, then confirm with the 'Select' button.
Ensure the antenna is properly connected and fully extended. Perform an 'Auto Tune' to search for available DAB stations. If the problem persists, try resetting the radio to factory settings.