Bush 5067189 411010 Instruction Manual
![Bush 5067189 411010 Radio manual cover](/images/rUrdkKsrMEgrfaorZPecItie/thumbs/thumb175x175.webp)
To set the frequency manually, use the tuning knob or buttons on the radio to adjust the frequency to your desired station. Refer to the user manual for specific button instructions.
Ensure that the radio is properly plugged into a power source or has fresh batteries installed. Check the power switch and make sure it is in the 'ON' position. If it still does not turn on, consult the troubleshooting section of the manual.
To improve reception, extend the antenna fully and adjust its position. Try relocating the radio to a different spot, preferably near a window. Avoid placing it near electronic devices that might cause interference.
Yes, you can preset stations by using the preset buttons on the radio. Tune to your desired station, then press and hold a preset button until it beeps or the display indicates the station is saved.
The radio uses standard AA batteries. Ensure you insert them according to the polarity markings inside the battery compartment.
To switch between AM and FM modes, use the mode selector button labeled 'AM/FM' on the radio. Press it to toggle between modes.
Check the volume control to ensure it is turned up. Verify that headphones are not plugged in, as this may mute the speakers. If the issue persists, refer to the troubleshooting guide in the manual.
Yes, the radio has a headphone jack where you can plug in standard 3.5mm headphones for private listening.
Clean the radio exterior with a soft, dry cloth regularly to prevent dust buildup. Avoid using cleaning agents or water to prevent damage to the electronics.
To reset the radio to factory settings, refer to the user manual for specific instructions, as the procedure may involve pressing a combination of buttons or accessing a reset function in the menu.