Brandt D2922 User Manual

To adjust the temperature settings, locate the temperature control panel inside the fridge. Use the up and down arrows to set your desired temperature. The recommended setting is 37°F (3°C) for the refrigerator and 0°F (-18°C) for the freezer.
First, ensure that the refrigerator is plugged in and the power is on. Check if the doors are closing properly and the seals are clean. Verify that the temperature settings are correct. If the issue persists, it might be necessary to clean the condenser coils or contact a service technician.
It's recommended to clean the condenser coils every 6 to 12 months to ensure efficient operation. Dust and debris can accumulate on the coils, reducing cooling efficiency.
Store raw meat on the bottom shelf to prevent drippings from contaminating other foods. Place dairy products and eggs on the middle shelves, and keep fruits and vegetables in the crisper drawers. Use the door shelves for condiments and beverages.
Check if the refrigerator is level and adjust the feet if needed. Ensure that it is not touching the wall or other objects. If the noise persists, inspect the fan and compressor for any issues or contact a technician.
Check if the drain hole at the back of the refrigerator is clogged and clean it if necessary. Ensure that food items are not blocking the air vents. If the problem continues, check the door seals for any damage.
Unplug the refrigerator for about 5 minutes, then plug it back in. This should reset the system. Check the temperature settings and adjust if necessary.
For leafy greens and vegetables, set the humidity control to high. For fruits, set it to low. This helps to maintain the optimal freshness and longevity of your produce.
Ice build-up can occur if the freezer door is not sealing properly. Check the door seal for any gaps or damage. Additionally, avoid leaving the freezer door open for extended periods.
Locate the water filter compartment, typically in the upper right corner of the refrigerator. Twist the old filter counterclockwise to remove it, and install the new filter by twisting it clockwise until it locks into place.