Brandt BFT511MSW User Manual
![Brandt BFT511MSW Refrigerator manual cover](/images/PgliWaNISdWSbuvHmyuTLJzh/thumbs/thumb175x175.webp)
To adjust the temperature settings, locate the control panel inside the refrigerator. Use the '+' and '-' buttons to set the desired temperature for both the refrigerator and freezer sections.
Ensure that the refrigerator is plugged in and the circuit breaker is not tripped. Check the temperature settings and make sure the vents inside the fridge are not blocked. Clean the condenser coils if they are dusty or dirty.
The Brandt BFT511MSW is a frost-free model, so manual defrosting is not required. However, if you notice ice buildup, check the door seals and ensure the door closes properly.
To clean the interior, first unplug the refrigerator. Remove all food items and shelves. Use a mixture of mild detergent and warm water to wipe down all surfaces. Rinse with clean water and dry with a soft cloth before reassembling.
Check if the refrigerator is level and adjust the feet if necessary. Make sure it is not touching the wall or cabinets. Listen to determine if the noise is coming from the compressor, fan, or other components and contact a technician if needed.
Locate the water filter compartment inside the refrigerator. Turn the filter counterclockwise to remove it. Install the new filter by turning it clockwise until it locks into place. Run water through the dispenser for a few minutes to purge air and impurities.
Inspect the door gasket for any damage or dirt. Clean it with a damp cloth to remove debris. If the gasket is damaged, it may need to be replaced to ensure a proper seal.
Ensure the refrigerator is not overloaded and that air can circulate freely inside. Keep the door closed as much as possible and ensure the door seals are intact. Set the temperature to the recommended settings and clean the condenser coils regularly.
First, check if the refrigerator is receiving power. If the light bulb is burnt out, replace it with a new one of the same type and wattage. If the problem persists, there may be an issue with the light switch or wiring.
To reset the alarm, press the alarm reset button on the control panel. If the alarm persists, check for any issues such as a door left ajar or high temperature inside the refrigerator.