BMW 750i Sedan 7 Series 2013 Owner's Manual

To reset the service light, turn on the ignition without starting the engine, press and hold the trip odometer reset button until the service menu appears. Use the toggle button on the turn signal lever to scroll to the service that needs resetting and hold the BC button until 'Reset?' appears. Press and hold the BC button again to confirm.
For optimal performance, use BMW Longlife-01 approved synthetic oil with a viscosity of SAE 5W-30 or 5W-40. Always refer to your owner's manual for the latest specifications.
Check for any warning lights on the dashboard, inspect the air springs for leaks, and listen for the air compressor's operation. If you suspect a problem, it's advisable to have the suspension system checked by a professional technician.
A rough idle might be caused by dirty fuel injectors, a faulty mass air flow sensor, or vacuum leaks. Regular maintenance and diagnostic checks can help identify and resolve these issues.
Ensure Bluetooth is enabled on your smartphone, then go to the iDrive menu. Select 'Communication', then 'Manage mobile devices', and choose 'Connect new device'. Follow the prompts to pair your phone.
The recommended tire pressure is usually around 32 psi for both front and rear tires. However, this can vary based on load and driving conditions, so always refer to the sticker on the driver's side door jamb or the owner's manual.
Maintain regular service intervals, ensure your tires are properly inflated, drive smoothly, and reduce unnecessary idling. Consider using premium fuel as recommended by BMW.
The check engine light can be triggered by numerous issues, ranging from a loose gas cap to more serious engine problems. Use an OBD-II scanner to read the error code, or have a professional diagnose the issue.
Try restarting the iDrive system by holding down the volume button for about 30 seconds. If the issue persists, check for software updates or consult your dealer for technical support.
To replace the key fob battery, slide the release button to remove the mechanical key. Then, open the back cover of the fob using a small flathead screwdriver. Replace the old battery with a new CR2032 battery, ensuring the positive side is facing up. Reassemble the fob.