BMW 528i Sedan 5 Series 2012 Owner's Manual
![BMW 528i Sedan 5 Series 2012 manual cover](/images/28244556d4b4b424642bf40c/thumbs/thumb175x175.webp)
To reset the service light on a 2012 BMW 528i, turn the ignition to the on position without starting the engine. Press and hold the odometer reset button until the service menu appears, then use the toggle switch on the indicator stalk to navigate and reset the service indicator.
The recommended oil for a 2012 BMW 528i is SAE 5W-30 full synthetic motor oil that meets BMW Longlife-01 specifications.
If the air conditioning is not working, check the refrigerant level, fuses, and A/C compressor. If these are fine, it may be an issue with the climate control module or a blocked condenser.
The recommended tire pressure for a 2012 BMW 528i is typically 32 PSI for the front tires and 35 PSI for the rear tires, but always check the sticker on the driver’s door jamb for specific recommendations.
To replace the battery in the key fob, remove the mechanical key by pressing the release button, open the key fob case using a small flathead screwdriver, and replace the old battery with a new CR2032 battery.
If the check engine light comes on, check for any obvious issues such as a loose gas cap. If the light persists, use an OBD-II scanner to read the diagnostic trouble codes or take your car to a professional mechanic for further diagnosis.
To change the brake fluid, ensure the car is on a level surface, remove the old fluid from the reservoir, fill with new DOT 4 brake fluid, and bleed each brake line starting from the furthest wheel from the master cylinder.
Reduced engine power can be caused by issues such as a faulty mass airflow sensor, clogged air filter, or problems with the throttle body. A diagnostic scan will help identify the exact cause.
It is recommended to change the spark plugs in your 2012 BMW 528i approximately every 60,000 miles to ensure optimal engine performance.
To replace a headlight bulb, open the hood and remove the headlight cover. Disconnect the electrical connector, release the bulb holder, and replace the old bulb with a new one. Ensure it is securely fastened and test the light before closing the cover.