Ariens 935 Series 935025 Parts Manual

To start the Ariens 935025 Tractor, ensure the PTO switch is disengaged, the parking brake is on, and the shift lever is in neutral. Turn the ignition key to the 'Start' position until the engine fires, then release it to the 'Run' position.
If the tractor won't start, check the battery connections, ensure the fuel tank has fuel, and verify the spark plug is functioning. Additionally, make sure the safety switches are not engaged.
Change the oil after the first 5 hours of use, then every 25 hours or at the start of each season thereafter. Always use the oil type recommended in the manual.
To adjust the cutting deck, ensure the tractor is on a flat surface. Use the lift lever to set the deck to the desired height. Adjust the deck leveling bolts if necessary to ensure even cutting.
Ensure the tires are properly inflated, the blades are sharp and balanced, and the deck is correctly leveled. Check for any obstructions or damage to the blades or deck.
At the end of the season, clean the tractor thoroughly, change the oil, sharpen the blades, and check the belts and filters. Store the tractor in a dry place after disconnecting the battery.
To replace the drive belt, first disconnect the battery. Remove the mower deck and the belt covers. Release the belt tension and remove the old belt. Install the new belt following the routing diagram, then reassemble the parts.
If the tractor overheats, check for debris blocking the air intake or radiator fins. Ensure the cooling system is functioning properly and the oil level is adequate. Allow the tractor to cool before resuming use.
To improve traction, ensure the tires are properly inflated. Consider adding wheel weights or using tire chains if necessary, especially in slippery conditions.
For winterizing, clean the tractor, change the oil, and add a fuel stabilizer to the fuel tank. Store the tractor with the battery disconnected in a dry, protected area. Cover the tractor to prevent dust and moisture accumulation.