Aiwa AQ-17-BTFM Instruction Manual
![Aiwa AQ-17-BTFM Radio manual cover](/images/sbCjinbtQhUWmrmWXMwdtNCI/thumbs/thumb175x175.webp)
To set the time on your Aiwa AQ-17-BTFM Radio, press and hold the 'Clock' button until the display starts flashing. Use the 'Tuning' buttons to adjust the hour and minute. Press 'Clock' again to save the settings.
If your radio won't turn on, check if it is properly plugged into a power source or if the batteries are installed correctly. Ensure the power switch is in the 'On' position. If the issue persists, try using a different power outlet or replacing the batteries.
To improve radio signal reception, try extending or repositioning the antenna. Place the radio near a window or away from electronic devices that may cause interference. You can also try scanning for stations again to ensure optimal tuning.
Yes, you can preset radio stations. Tune to the desired station, then press and hold one of the preset buttons (1-5) until you hear a beep. The station is now saved to the selected preset button.
To switch between AM and FM modes, press the 'Band' button on the radio. Each press will toggle between AM and FM modes.
To clean your radio, use a soft, dry cloth to wipe the exterior. Avoid using any liquid cleaners or abrasive materials. For stubborn dirt, slightly dampen the cloth with water and gently clean the surface.
To reset your radio to factory settings, locate the 'Reset' button (usually near the battery compartment). Use a pointed object to press and hold the button for a few seconds until the display resets.
Yes, you can connect external speakers to the Aiwa AQ-17-BTFM via the headphone jack. Use an appropriate cable to link the radio to your speakers.
If the sound is distorted, ensure that the volume is not set too high, which can cause distortion. Check if the radio is tuned correctly to a station and that the antenna is properly positioned. Adjusting these settings should help improve sound quality.
To change the batteries, open the battery compartment located at the back of the radio. Remove the old batteries and insert new ones, ensuring the correct polarity (+/-). Close the compartment securely.