Viking VURE515G Installation Guide
![Viking VURE515G Refrigerator manual cover](/images/OdPPAypTIyDAPjYUAwAsXLVY/thumbs/thumb175x175.webp)
To adjust the temperature settings, locate the control panel inside the unit. Use the up and down arrow buttons to set your desired temperature. Ensure the refrigerator is not overcrowded to allow proper air circulation.
First, check if the unit is plugged in and the circuit breaker is not tripped. Ensure the temperature settings are correct. Clean the condenser coils located at the back of the unit, and make sure the door seals are intact and free from obstructions.
The Viking VURE515G is a frost-free model and should not require manual defrosting. If you notice frost buildup, ensure the door is closing properly and check the seals. If the issue persists, consult a professional technician.
Use a soft cloth and a solution of mild soap and warm water to clean the interior. Avoid abrasive cleaners and ensure all surfaces are thoroughly dried before restocking the refrigerator.
Unusual noises can be caused by items inside the refrigerator vibrating. Ensure nothing is touching the walls and that the refrigerator is level. Additionally, check the condenser fan and evaporator fan for any debris or obstructions.
The water filter should be replaced approximately every 6 months, or when the water flow decreases significantly. Always use compatible filters designed for your Viking model.
Check if the drain hole at the back of the refrigerator is clogged. Clean it with a pipe cleaner or similar tool. Ensure food items are not blocking the air vents, which could cause condensation.
Yes, the door swing direction can be changed. Refer to the user manual for detailed instructions, as it involves removing the door and hinges and reinstalling them on the opposite side.
The Viking VURE515G requires a standard 115V, 60Hz electrical outlet. Ensure the outlet is properly grounded and avoid using extension cords.
To reset the control panel, unplug the refrigerator from the power source for about 5 minutes and then plug it back in. This should reset the system. If problems persist, contact customer support.