Viking VGR530 Use and Care Manual
![Viking VGR530 Range manual cover](/images/yLyxpsQxgIEylfzBakUPzToq/thumbs/thumb175x175.webp)
To clean the burner grates, remove them from the range and soak them in a mixture of warm water and mild dish soap. Use a non-abrasive scrub pad to remove any residue. Rinse thoroughly and dry completely before placing them back on the range.
First, ensure that the range is plugged in and the gas supply is on. Check the oven's temperature settings and make sure the door is fully closed. If the issue persists, it may be a faulty igniter or thermostat, and a professional technician should be consulted.
To calibrate the oven temperature, preheat the oven and place an oven thermometer inside. Compare the thermometer reading with the set temperature. If there's a discrepancy, refer to the user manual for instructions on adjusting the thermostat settings.
Use a soft cloth and a cleaner specifically designed for stainless steel. Apply the cleaner in the direction of the grain to avoid streaks and wipe with a clean, dry cloth to prevent water spots.
Uneven flames can be caused by clogged burner ports. Turn off the burner, allow it to cool, and clean the ports with a small brush or a pin to remove any obstructions. Ensure the burner caps are properly placed.
Use cookware with a flat bottom that is appropriately sized for the burner. Adjust the flame so it doesn't extend beyond the edge of the cookware. Stir frequently and reduce the heat as needed.
Regularly check and clean the burner grates, caps, and the oven cavity. Inspect the gas connections for leaks and ensure the range is level. Periodically check the door gasket for any wear or damage.
To replace the oven light bulb, ensure the oven is cool and unplugged. Remove the glass cover by turning it counterclockwise. Replace the bulb with a new one of the same type and wattage, then reattach the cover.
A clicking noise is normal as it indicates the electric igniter is working to light the burner. If the noise continues after ignition, ensure the burner cap is properly aligned and clean the igniter to remove any debris.
Remove all racks and accessories from the oven. Close the oven door and select the self-cleaning mode on the control panel. Follow the instructions in the user manual for the duration and any additional steps required.