Viking DFIM150D Installation Guide

To reset the Viking DFIM150D refrigerator after a power outage, press and hold the reset button located on the control panel for 5 seconds. This will restore the default settings.
Ensure that the refrigerator is plugged in and the thermostat is set correctly. Check for any blockages in the air vents and clean the condenser coils. If the issue persists, consult the user manual or contact customer support.
It is recommended to clean the condenser coils every 6 months to ensure optimal performance and energy efficiency.
To defrost the freezer section of the Viking DFIM150D, turn off the refrigerator and remove all items. Leave the freezer door open to allow the ice to melt. Use towels to absorb water and clean any remaining ice with a soft cloth.
Water pooling at the bottom of the refrigerator may be due to a blocked defrost drain. Clear the blockage using a mixture of warm water and baking soda, and ensure the drain is clear of debris.
To change the water filter, locate the filter compartment, twist the old filter counterclockwise to remove it, and insert the new filter. Twist it clockwise until it locks into place.
Ensure the ice maker is turned on and the water supply line is connected. Check for any ice blockages in the maker and reset the ice maker if necessary. If the problem persists, consider contacting a service technician.
Ensure the refrigerator is level and not touching any walls or cabinets. Check for any loose parts or panels. If the noise continues, contact a service technician for further assistance.
The recommended temperature setting for the refrigerator compartment is 37°F (3°C) and for the freezer compartment is 0°F (-18°C).
To safely move the refrigerator, empty all contents and secure shelves and drawers. Use a dolly to transport it, keeping it upright to prevent damage to the compressor. Avoid tilting it more than 45 degrees.