Toyota Venza 2014 Owner's Manual

To reset the maintenance light on a 2014 Toyota Venza, turn the ignition to the "On" position without starting the engine. Use the Odometer button to set the display to ODO mode. Turn off the ignition, then hold the Odometer button while turning the ignition back to "On." Hold the button until the maintenance light blinks and goes out.
The 2014 Toyota Venza typically requires SAE 0W-20 synthetic oil for optimal performance and fuel efficiency. Always check the owner’s manual or consult with a certified technician for confirmation.
To pair your phone with the Bluetooth system in a 2014 Toyota Venza, press the “Setup” button on the audio system, select “Bluetooth,” then “Add New Device.” Ensure your phone’s Bluetooth is turned on and search for the vehicle. Once detected, select it, and confirm the passkey if required.
The recommended tire pressure for a 2014 Toyota Venza is typically 32 psi for both front and rear tires. Always verify with the placard located on the driver’s side door jamb for the most accurate information.
To replace the cabin air filter in a 2014 Toyota Venza, open the glove compartment and remove the limiter arm. Press the sides of the glove box inward to release it. Locate the air filter cover behind the glove box, unclip it, and replace the old filter with a new one. Reassemble in reverse order.
A squealing noise when starting the 2014 Toyota Venza could indicate a worn or loose serpentine belt. It is advisable to check the belt for wear and proper tension and replace it if necessary. Consulting a mechanic is recommended if the issue persists.
The AWD system in the 2014 Toyota Venza is automatic and engages based on driving conditions. It does not require manual activation. The system continuously monitors conditions and distributes power to the wheels with the best traction.
If the key fob for your 2014 Toyota Venza is not working, try replacing the battery. Open the key fob by removing the screw or separating the halves carefully, replace the old battery with a new CR2032 battery, and reassemble the key fob.
To check the transmission fluid in a 2014 Toyota Venza, ensure the vehicle is on a level surface and has reached normal operating temperature. Pull the dipstick out, wipe it clean, reinsert it, and then pull it out again to check the fluid level. The level should be between the "Full" and "Add" marks.
The towing capacity of a 2014 Toyota Venza is typically 3,500 pounds when properly equipped. Ensure your vehicle has the necessary towing package and always refer to the owner’s manual for specific guidelines and limitations.