Toyota Sienna 2004 Owner's Manual
![Toyota Sienna 2004 Minivan manual cover](/images/nSZYsoZWndNcyEnnyIbrrgIa/thumbs/thumb175x175.webp)
The recommended oil type for a 2004 Toyota Sienna is 5W-30. It is important to use the correct viscosity to ensure optimal engine performance and longevity.
The timing belt on a 2004 Toyota Sienna should be replaced every 90,000 miles or 6 years, whichever comes first. Regular replacement is crucial to prevent engine damage.
The 2004 Toyota Sienna has a towing capacity of up to 3,500 pounds when properly equipped. Ensure the vehicle is fitted with the correct towing package.
To reset the maintenance light, turn the ignition key to the 'ON' position without starting the engine. Press the odometer button until the display reads the total mileage (not trip mileage). Turn the key off. Hold the odometer button while turning the key back to 'ON'. The light will blink and then go out.
The recommended tire pressure for a 2004 Toyota Sienna is typically 35 psi for both front and rear tires. Check the owner's manual or the sticker on the driver's side door jamb for confirmation.
To improve fuel efficiency, maintain proper tire pressure, perform regular maintenance such as oil changes and air filter replacements, drive at moderate speeds, and avoid excessive idling.
A squeaking noise when braking could indicate worn brake pads, glazed rotors, or a lack of lubrication on the brake hardware. It is advisable to have the brakes inspected by a professional.
To replace the cabin air filter, open the glove box and remove the damper by sliding it off the pin. Press in on both sides of the glove box to release it from the dashboard. The cabin air filter is located behind a rectangular cover that can be unclipped and removed. Replace the old filter with a new one and reassemble.
If the engine overheats, pull over safely and turn off the engine. Allow it to cool before checking the coolant level. If necessary, add coolant once the engine has cooled. Inspect for leaks or damaged components and seek professional assistance if the problem persists.
To program a new keyless entry remote, insert the key into the ignition and turn it to the 'ON' position. Within 5 seconds, press the lock and unlock buttons on the remote simultaneously for 1.5 seconds, then release. Immediately press and hold the lock button for 2 seconds. The door locks should cycle to confirm programming.