Suzuki V-STROM 650 DL650A 2017 Owner's Manual
![Suzuki V-STROM 650 DL650A 2017 Motorcycle manual cover](/images/hUeLTFobJQwZddRoqHNXRQch/thumbs/thumb175x175.webp)
To change the oil, first warm up the engine for a few minutes to thin the oil. Turn off the engine and remove the oil fill cap. Place an oil pan under the engine, remove the drain plug and let the oil drain. Replace the drain plug and remove the oil filter. Install a new oil filter and pour new oil into the engine. Check the oil level and add more if necessary.
The recommended tire pressure for the Suzuki V-STROM 650 DL650A 2017 is 33 psi for the front tire and 36 psi for the rear tire. It's important to check tire pressures when the tires are cold for accurate readings.
If the motorcycle won't start, first check the battery to ensure it's charged and the terminals are clean. Verify that the kill switch is in the 'run' position. Ensure the fuel valve is open and there's sufficient fuel. Check the fuses and inspect the starter motor connections. If the issue persists, consult a mechanic.
Use a high-quality ethylene glycol-based antifreeze coolant, which is specifically formulated for aluminum engines. Ensure the coolant is mixed to a 50/50 ratio with distilled water for optimal performance.
The chain should be lubricated every 500 miles or sooner if the bike is ridden in wet or dusty conditions. Use a high-quality chain lubricant and apply it evenly over the chain while spinning the rear wheel.
The valve clearance for the Suzuki V-STROM 650 DL650A 2017 should be checked and adjusted by a professional. Generally, intake valve clearance is 0.10-0.20 mm and exhaust valve clearance is 0.20-0.30 mm. Refer to the service manual for exact specifications.
To improve fuel efficiency, maintain proper tire pressure, perform regular maintenance such as oil changes and air filter replacements, ride at moderate speeds, and avoid aggressive acceleration and braking.
The recommended spark plug for the Suzuki V-STROM 650 DL650A 2017 is the NGK CR8E or equivalent. Ensure the spark plugs are gapped correctly to 0.7-0.8 mm before installation.
To reset the maintenance light, turn off the ignition. Press and hold the 'Select' button on the dashboard. While holding the button, turn on the ignition and continue holding the button until the light resets.
If the motorcycle overheats, safely pull over and turn off the engine. Allow the bike to cool down before inspecting the coolant level. Check for leaks and ensure the radiator is not blocked. Refill the coolant if necessary and inspect the cooling fan operation. If the problem persists, seek professional maintenance.