Sony ZS-S3iPN v2 Operating Instructions
![Sony ZS-S3iPN manual cover](/images/b47a9ca9c1904c4e6dc0cbef/thumbs/thumb175x175.webp)
To set the clock, press the 'Clock' button until the time display flashes. Use the 'Tuning/Time Set +/-' buttons to adjust the hour and minute. Press 'Clock' again to confirm the setting.
Ensure the FM/AM antenna is fully extended. Try repositioning the unit or the antenna for better reception, and avoid placing the unit near devices that may cause interference.
Check if the CD is inserted correctly with the label side up. Clean the CD and the CD lens if necessary. Ensure the CD is not scratched or damaged. If the problem persists, reset the unit by unplugging it for a few minutes.
Use the built-in iPod dock located on the top of the unit. Ensure the iPod is compatible and securely connected. Use the 'Function' button to switch to iPod mode and operate using the controls on the unit or the iPod itself.
Use a soft, dry cloth to wipe the exterior. Avoid using harsh chemicals or solvents. For the CD lens, use a dedicated CD lens cleaner if necessary.
Yes, the unit can run on six 'C' size batteries. Battery life depends on usage but typically lasts about 10 hours for radio playback. Be sure to remove batteries if the unit is not used for an extended period to prevent leakage.
To reset the unit, disconnect the power source and remove any batteries. Press and hold the 'Power' button for a few seconds. Reconnect the power and turn the unit back on.
Check that the volume is turned up on both the unit and the connected device. Ensure the 'Mega Bass' is not turned off. If using the radio, check the reception and antenna position.
Ensure the power cord is securely connected and the outlet is functioning. If using batteries, check that they are installed correctly and replace them if depleted. If the issue persists, try resetting the unit.
To program stations, tune to the desired station, then press and hold the desired preset button (1-3) until you hear a beep. The station is now stored and can be accessed by pressing the preset button.