Sony STR-DE345 Operating Instructions
![Sony STR-DE345 manual cover](/images/e313f8722eed02beb735cef1/thumbs/thumb175x175.webp)
To reset the Sony STR-DE345 to factory settings, turn off the unit, then press and hold the "Power" button while pressing the "Enter" button. Hold both buttons until "All Clear" or a similar message appears on the display.
First, ensure all speaker wires are connected properly. Check if the receiver is set to the correct input source. Also, confirm that the 'Mute' function is not enabled and the volume is turned up.
Connect external audio equipment using the appropriate RCA cables to the available input jacks on the back of the receiver, such as CD, Tape, or Video inputs. Select the corresponding input source on the receiver to play audio from the connected equipment.
The Sony STR-DE345 is compatible with speakers that have an impedance of 8 ohms. Using speakers with a lower impedance may cause the receiver to overheat or become damaged.
Improving FM radio reception can be achieved by extending the FM antenna wire fully and positioning it for best reception. You may also consider using an external FM antenna for better signal strength.
First, replace the batteries in the remote control. Ensure there are no obstructions between the remote and the receiver. If the problem persists, try resetting the remote by removing the batteries and pressing all buttons.
Yes, you can connect a subwoofer to the Sony STR-DE345 using the 'Subwoofer Out' jack on the rear panel. Make sure the subwoofer is powered and set to the correct input mode.
To calibrate speaker levels, use the 'Test Tone' function in the receiver's setup menu. Adjust the levels for each speaker channel to ensure balanced sound from your listening position.
This issue might be due to overheating or a speaker wire short circuit. Ensure the receiver has proper ventilation and check all speaker connections for shorts or damage.
Press the 'Sleep' button on the remote control. Each press of the button will increase the timer by 10 minutes. Select your desired duration, and the receiver will automatically turn off after the set time.