Sony ICF-C717PJ Operating Instructions
![Sony ICF-C717PJ manual cover](/images/4c2ebdbc6505789f499068d3/thumbs/thumb175x175.webp)
To set the time, press and hold the TIME SET button until the hour digits flash. Use the + and - buttons to set the correct hour. Press TIME SET again to confirm and move to the minutes. Repeat the process for setting minutes, and press TIME SET to save.
To project the time, press the PROJECTOR ON/OFF button on the unit. Adjust the focus with the focus dial until the projection is clear. Ensure the unit is positioned to project on a flat surface.
Check if the alarm is set correctly by pressing the ALARM button and ensuring the alarm icon appears on the display. Verify the volume is not set to zero and check the power supply if using a backup battery.
To change the alarm sound, press the ALARM button repeatedly to cycle through available sound options, such as radio or buzzer. Confirm your selection by not pressing any buttons for a few seconds.
Yes, the Sony ICF-C717PJ has a USB port that can be used to charge smartphones. Connect your device using a compatible USB cable to start charging.
Ensure the FM wire antenna is fully extended and positioned for the best reception. Avoid placing the unit near electrical appliances that may interfere with radio signals. If the issue persists, try repositioning the unit.
The backup battery ensures that the clock and alarm settings are retained during a power outage. It does not power the radio or projector functions. Make sure to replace the battery regularly for reliable backup.
To improve projection brightness, ensure the projector lens is clean and the room is sufficiently dark. The brightness may also be limited by ambient lighting conditions. Adjusting the focus may help enhance clarity.
To disable daylight saving time, press and hold the DST button until the display shows "OFF". This will prevent the clock from automatically adjusting for daylight saving changes.
To reset the unit, locate the RESET button on the bottom of the device. Use a pointed object to press the button gently. This will restore the unit to its factory default settings.