Sony ICF-860 Specification
Sony ICF-860 F.A.Q.
How do I set the alarm on my Sony ICF-860?
To set the alarm on your Sony ICF-860, press and hold the 'Alarm Set' button until the display begins to flash. Use the 'Hour' and 'Minute' buttons to adjust the time, and confirm by pressing 'Alarm Set' again.
What should I do if my Sony ICF-860 is not turning on?
Ensure the device is properly plugged into a power source or that fresh batteries are installed. If the problem persists, try resetting the device by unplugging it for a few minutes and then reconnecting it.
How can I improve the radio reception on my Sony ICF-860?
To improve radio reception, fully extend the antenna and adjust its position. Avoid placing the radio near other electronic devices that might cause interference.
Why is the display on my Sony ICF-860 dim?
Check the display brightness settings by pressing the 'Display' button. If the brightness is already at maximum, the device may need a power reset or fresh batteries if running on battery power.
Can I use rechargeable batteries in my Sony ICF-860?
Yes, you can use rechargeable batteries. Ensure they are fully charged and that the battery compartment is clean and free from corrosion.
How do I switch between AM and FM modes on the Sony ICF-860?
To switch between AM and FM modes, press the 'Band' button until the desired band appears on the display.
What is the procedure to reset my Sony ICF-860 to factory settings?
To reset the Sony ICF-860 to factory settings, unplug the device from any power source, remove the batteries, and leave it disconnected for a few minutes before reconnecting.
How do I adjust the volume on my Sony ICF-860?
Adjust the volume by turning the 'Volume' knob located on the side of the device until the desired level is reached.
What type of batteries does the Sony ICF-860 require?
The Sony ICF-860 requires 4 AA batteries for portable operation. Ensure you use high-quality batteries for optimal performance.
How do I clean my Sony ICF-860?
Clean your Sony ICF-860 with a soft, damp cloth. Avoid using harsh chemicals or abrasive materials that could damage the surface.