Sencor SRD 210 BS Instruction Manual
![Sencor SRD 210 BS Radio manual cover](/images/niNcMntdbSgVYZmFjHePGIfD/thumbs/thumb175x175.webp)
To change the frequency, use the tuning knob on the side of the radio. Turn the knob slowly to adjust the frequency until you find the desired station.
First, check if the batteries are inserted correctly and are not depleted. If using an AC adapter, ensure it is properly connected. If the problem persists, try replacing the batteries or using a different power source.
To improve reception, extend the telescopic antenna fully and adjust its direction. Avoid placing the radio near electronic devices that may cause interference.
Yes, you can connect headphones to the Sencor SRD 210 BS radio using the headphone jack located on the side of the device.
Clean the radio with a soft, dry cloth. Avoid using any liquids or harsh chemicals to prevent damage to the radio's surface and internal components.
To reset the radio to factory settings, remove the batteries and disconnect any power source. Wait for a few minutes before reconnecting the power. This will reset the radio.
The Sencor SRD 210 BS radio uses AA batteries. It is recommended to use high-quality alkaline batteries for optimal performance.
To switch between AM and FM modes, locate the AM/FM switch on the radio and toggle it to the desired mode.
Distorted sound can be due to weak signal reception or low battery power. Try repositioning the antenna and replacing the batteries to see if the issue resolves.
The Sencor SRD 210 BS radio does not support external antennas. For better reception, use the built-in telescopic antenna and adjust its position.