Sencor SPT 2320 Instruction Manual

To connect your Sencor SPT 2320 Boombox to a Bluetooth device, ensure the Boombox is in Bluetooth mode. Then, activate Bluetooth on your device and search for available devices. Select "SPT 2320" from the list to pair.
First, check if the Boombox is properly plugged into a power source. If it is using batteries, ensure they are inserted correctly and have charge. If the problem persists, try using a different power outlet or set of batteries.
To improve FM radio reception, fully extend the antenna and adjust its position for the best signal. You may also try repositioning the Boombox to reduce interference.
Use a soft, dry cloth to wipe the exterior of the Boombox. Avoid using any harsh chemicals or water directly on the unit. For stubborn stains, a slightly damp cloth can be used, followed by a dry cloth.
Press and hold the "Clock" button until the time display flashes. Use the "Skip" buttons to adjust the hour and minute. Press "Clock" again to set the time.
Yes, you can play music from a USB drive by inserting it into the USB port on the Boombox. Use the mode button to select USB mode and the playback controls to navigate tracks.
Ensure the CD is clean and free from scratches. Check that the Boombox is on a stable surface. If skipping persists, try a different CD to determine if the issue is the disc or the player.
Check the volume level and ensure it's not set to zero or muted. Verify that the correct audio source is selected. Inspect the headphone jack for any obstructions if headphones are not in use.
To reset the Boombox, disconnect it from the power source, wait for about 30 seconds, and then reconnect. This should restore the default factory settings.
The Sencor SPT 2320 Boombox uses 6 size C (R14) batteries. Ensure they are inserted according to the polarity indicated in the battery compartment.