Scion xB 2011 Quick Reference Guide

To reset the maintenance required light, turn the ignition to the 'ON' position without starting the engine. Press and hold the trip meter reset button, then turn the ignition to 'OFF'. Continue holding the button while turning the ignition back to 'ON'. The light should flash and then turn off. Release the button to complete the reset.
The 2011 Scion xB requires 5W-20 or 0W-20 engine oil. Using synthetic oil is recommended for optimal performance and efficiency. Always check your owner's manual for the most accurate information.
To change the air filter, first open the hood and locate the air filter housing on the driver's side of the engine compartment. Unclip the clamps or screws holding the cover, remove the old filter, and insert a new one. Ensure it fits snugly, then secure the housing cover back in place.
The recommended tire pressure for the 2011 Scion xB is 33 psi for both front and rear tires. Always check the tire information placard located on the driver's side door jamb for the most accurate specifications.
To improve fuel efficiency, keep your tires properly inflated, perform regular maintenance such as oil changes and air filter replacements, and drive smoothly, avoiding rapid acceleration and braking. Reducing excess weight and using cruise control on highways can also help.
The 2011 Scion xB is not designed for towing. Refer to the owner's manual for any specific guidelines or consult with a Scion dealership for further assistance.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector, remove the rubber cover, and unclip the bulb holder. Replace with a new bulb, ensuring not to touch the glass, and reassemble in reverse order.
Common issues include excessive oil consumption and brake wear. Ensure regular oil checks and maintain proper levels. For brakes, replace pads and rotors as needed. Regular inspections can help identify and resolve these issues early.
To replace the key fob battery, locate the notch on the side of the fob and use a flathead screwdriver to gently pry it open. Remove the old battery and insert a new CR2032 battery with the positive side facing up. Snap the fob back together securely.
To jump-start the vehicle, connect the positive cable to the positive terminal of the dead battery and the other end to the positive terminal of the donor battery. Connect the negative cable to the negative terminal of the donor battery and the other end to an unpainted metal surface on the engine block of the dead car. Start the donor car, then attempt to start the Scion xB. Remove cables in reverse order once started.