Samsung NV51K7770D Installation Guide

To perform a self-cleaning cycle, remove all racks and accessories from the oven. Close the oven door, select 'Self Clean' on the control panel, and choose the desired cleaning duration. Press 'Start' to begin the cycle. Ensure the area is well-ventilated as the oven will reach high temperatures.
If the oven does not heat properly, check if it is correctly plugged in and the circuit breaker is not tripped. Confirm that the oven is not in demo mode. If issues persist, inspect the heating elements for damage or consult a professional technician.
To calibrate the oven temperature, press 'Options' on the control panel. Use the arrow keys to select 'Temp Adjustment'. Adjust the temperature as needed using the arrow keys, then press 'OK' to save the changes.
Refer to the user manual for specific error code meanings and troubleshooting steps. Common solutions include resetting the oven by turning off the circuit breaker for a few minutes or checking for obstructions in the oven door or vents.
While you can use aluminum foil in the oven, it should not cover the entire oven rack or touch the heating elements, as this can disrupt airflow and cause uneven cooking. Use it sparingly, such as lining a baking sheet.
It is recommended to perform a self-cleaning cycle every 3 to 6 months, depending on usage. Regularly wipe spills and debris after each use to prevent buildup.
Remove the racks and soak them in warm, soapy water for several hours. Use a non-abrasive scrubber to remove stubborn stains. Rinse thoroughly and dry completely before placing them back in the oven.
To use the delay start function, press 'Delay Start' on the control panel. Set the desired start time using the arrow keys, then select the cooking function and temperature. Press 'Start' to activate the delay timer.
Ensure there are no obstructions or debris around the door seal. Check that the hinges are not damaged. If the problem persists, the door latch may need adjustment or replacement by a professional.
To replace the oven light bulb, first disconnect the oven from power. Remove the glass cover over the bulb by turning it counterclockwise. Replace the bulb with a new one of the same type and wattage. Reattach the cover and reconnect the oven to power.