Ram Cargo 2014 Owner's Manual

The recommended oil type for the 2014 Ram Cargo Van is 5W-20 synthetic blend motor oil.
To reset the maintenance light, turn the ignition to the "ON" position without starting the engine, press the gas pedal slowly three times within 10 seconds, and then turn the ignition off.
The 2014 Ram Cargo Van has a towing capacity of up to 3,600 pounds when properly equipped.
To improve fuel efficiency, ensure regular maintenance, keep tires properly inflated, drive at steady speeds, and remove excess weight from the van.
The recommended tire pressure for the 2014 Ram Cargo Van is typically 36 PSI for both front and rear tires, but always check the placard on the driver's side door jamb for the most accurate information.
To replace a headlight bulb, open the hood, disconnect the power connector from the back of the headlight, remove the old bulb, and insert the new bulb. Reconnect the power connector and test the light before closing the hood.
Common causes of stalling include issues with the fuel system, faulty spark plugs, or a malfunctioning idle air control valve. A diagnostic scan can help pinpoint the exact issue.
It is recommended to change the transmission fluid every 60,000 miles under normal driving conditions. Check your owner's manual for specific intervals based on your usage.
To jump-start the van, connect the positive cable to the positive terminal of the dead battery and the other end to the positive terminal of the good battery. Then, connect the negative cable to the negative terminal of the good battery and the other end to a metal part of the dead vehicle's engine block. Start the engine of the good vehicle and then the van.
To check the brake fluid level, locate the brake fluid reservoir under the hood, clean the cap before opening, and ensure the fluid level is between the "MIN" and "MAX" marks on the reservoir.