Ram 2500 2020 Owner's Manual

To check the engine oil level, park your truck on a level surface, turn off the engine, and wait a few minutes for the oil to settle. Open the hood and locate the dipstick. Pull the dipstick out, wipe it clean with a rag, reinsert it fully, and then pull it out again to check the oil level. Ensure the oil level is between the "MIN" and "MAX" marks.

The recommended tire pressure for the 2020 Ram 2500 is typically found on the placard located inside the driver's door jamb. It generally ranges from 60 psi for the front tires to 80 psi for the rear tires, but you should verify the specific pressure for your vehicle configuration.

To reset the oil change indicator, turn the ignition switch to the "ON" position without starting the engine. Fully depress the accelerator pedal slowly three times within 10 seconds. Turn the ignition switch to the "OFF" position. If done correctly, the oil change light should reset.

If the check engine light illuminates, ensure the gas cap is tightened securely, as a loose cap is a common cause. If the light remains on, consider using a diagnostic scanner to retrieve error codes or consult a professional mechanic for a thorough inspection, as it may indicate other issues.

To pair your phone, ensure Bluetooth is enabled on your device. On the Uconnect screen, go to "Phone" > "Add Device" and select your phone from the list of discoverable devices. Follow the on-screen prompts to complete the pairing process, including verifying the PIN if necessary.

The 2020 Ram 2500 has a maximum towing capacity of up to 19,680 pounds, depending on the engine and configuration. For precise capabilities, refer to the owner's manual or the manufacturer's official specifications for your specific model and setup.

To perform a factory reset on the Uconnect system, navigate to "Settings" > "System Information" > "Reset" on the Uconnect screen. Confirm the reset action. This will erase all personal data and settings, returning the system to factory default.

It is recommended to rotate the tires every 6,000 to 8,000 miles to ensure even wear and extend tire life. Always follow the specific rotation pattern outlined in the owner's manual for optimal performance.

The 2020 Ram 2500 typically requires regular unleaded gasoline with an octane rating of 87 or higher. For diesel engines, use ultra-low sulfur diesel fuel. Always consult your owner's manual for the correct fuel type for your specific model.

To replace the air filter, open the hood and locate the air filter housing. Unclip or unscrew the housing cover, remove the old filter, and insert a new one, ensuring it is seated properly. Replace the cover and secure it with clips or screws.