Pontiac Montana 2002 Owner's Manual
![Pontiac Montana 2002 manual cover](/images/MeHjLzgBojMQswDPrOanCMKd/thumbs/thumb175x175.webp)
To reset the 'Change Oil' light, turn the ignition to the 'On' position without starting the engine. Press the gas pedal fully three times within five seconds. The light should flash and then go off, indicating the reset is complete.
The recommended tire pressure for a 2002 Pontiac Montana is typically 35 PSI for both front and rear tires. Always check the owner's manual or the sticker inside the driver's door for specific information.
First, check the fuse for the power windows. If the fuse is fine, test the window switch by swapping it with another switch. If the switch isn't the problem, the window motor or regulator might need replacement.
For a 2002 Pontiac Montana, it is recommended to use 5W-30 engine oil. Make sure to choose an oil that meets the API certification standards.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the retaining clips or screws, disconnect the wire harness, and carefully remove the old bulb. Insert the new bulb without touching the glass, reconnect the harness, and secure the assembly.
Common causes of overheating include a low coolant level, a faulty thermostat, or a failing water pump. Check for leaks, ensure the coolant is topped up, and inspect these components. If unsure, consult a mechanic for a thorough diagnosis.
The 2002 Pontiac Montana is equipped with a timing chain rather than a timing belt, which typically does not require regular replacement. However, it should be inspected regularly for wear or damage.
If the ABS light is on, it indicates an issue with the anti-lock braking system. Check the ABS fuse and inspect the wheel speed sensors for dirt or damage. If the problem persists, have a professional diagnostic performed.
To replace the battery, turn off the ignition and remove the negative battery cable, followed by the positive cable. Remove any securing brackets, then lift out the old battery. Place the new battery in, secure it with brackets, and reconnect the positive cable first, then the negative.
Common transmission issues include slipping, hard shifting, and delayed engagement. Regular maintenance such as fluid changes can prevent these problems. If issues occur, it may be necessary to inspect the transmission for worn components or consult a transmission specialist.