Pontiac Bonneville 2002 Owner's Manual

To reset the oil change light, turn the ignition to the "On" position without starting the engine. Then, press the accelerator pedal to the floor three times within five seconds. The oil change light should flash and then turn off, indicating it has been reset.
The recommended engine oil for a 2002 Pontiac Bonneville is 5W-30. Always check the owner's manual for any specific requirements or updates.
If the ABS light is on, it could indicate a problem with the wheel speed sensors or the ABS module. Start by checking the wheel speed sensors for dirt or damage. If the issue persists, a diagnostic scan tool may be needed to read error codes.
The recommended tire pressure for a 2002 Pontiac Bonneville is typically 30 PSI for both front and rear tires. Always check the placard on the driver's door jamb for the most accurate information.
To improve fuel efficiency, ensure that your tires are properly inflated, perform regular maintenance like oil changes and air filter replacements, and avoid aggressive driving habits. Keeping your car well-tuned can also contribute to better gas mileage.
Common causes of overheating include a faulty thermostat, low coolant levels, or a malfunctioning radiator fan. Check the coolant level and inspect hoses for leaks. If the problem persists, consider having the thermostat and radiator fan checked by a professional.
To change the spark plugs, first disconnect the negative battery cable. Remove the ignition coil packs to access the spark plugs. Use a spark plug socket to remove the old plugs and install new ones, ensuring they are properly gapped. Reinstall the ignition coils and reconnect the battery.
First, check the fuse for the power windows. If the fuse is intact, the issue may be with the window motor or switch. Test the switch for power and, if necessary, check the motor. Replacement of faulty components may be required.
A rough idle can be caused by a dirty throttle body, vacuum leaks, or faulty spark plugs. Cleaning the throttle body and checking for leaks or damaged spark plugs can help resolve the issue.
To replace the brake pads, lift the vehicle and remove the wheels. Remove the caliper bolts and slide the caliper off the rotor. Remove the old brake pads and install new ones. Reattach the caliper and wheels, then lower the vehicle. Ensure the brake fluid reservoir is full and test the brakes before driving.