Pontiac Bonneville 1999 Owner's Manual
![Pontiac Bonneville 1999 manual cover](/images/oORVYbZWAcxGQDpvhtsPAgMM/thumbs/thumb175x175.webp)
To change the oil, first ensure the car is on a level surface. Remove the oil filler cap, then drain the oil by removing the drain plug from the oil pan. Replace the oil filter, reinstall the drain plug, and refill the engine with the recommended oil type and amount.
For a 1999 Pontiac Bonneville, use a 50/50 mixture of Dex-Cool coolant and distilled water. This type of coolant is specifically formulated for GM vehicles.
To reset the "Check Engine" light, fix the underlying issue, then use an OBD-II scanner to clear the error code. Alternatively, disconnect the battery for about 15 minutes, but be aware this may reset other electronic systems.
The recommended tire pressure for a 1999 Pontiac Bonneville is typically 30-32 PSI for both front and rear tires. Always check the owner’s manual or the placard on the driver’s side door jamb for accurate specifications.
Common causes for overheating include a faulty thermostat, clogged radiator, low coolant level, or a malfunctioning water pump. Check these components and ensure the cooling system is functioning properly.
To replace the serpentine belt, first locate the belt tensioner and use a wrench to relieve tension. Slide the old belt off and install the new belt following the belt routing diagram. Ensure the belt is seated properly on all pulleys.
Transmission slipping can be caused by low or old transmission fluid, worn-out clutches, or a faulty transmission solenoid. Check the fluid level and condition first, then inspect the transmission components if the problem persists.
To replace a headlight bulb, open the hood and locate the back of the headlight assembly. Remove the retaining clips or screws, disconnect the electrical connector, and replace the old bulb with a new one. Reassemble in reverse order.
A rough idle can be caused by dirty fuel injectors, a clogged air filter, faulty spark plugs, or a vacuum leak. Cleaning or replacing these components can often resolve the issue.
Start by checking the fuse for the power windows. If the fuse is intact, inspect the window switch and the wiring for any signs of damage. If these components are functioning, the window motor may need to be replaced.