Pontiac Montana 2000 Owner's Manual

To reset the oil change light, turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal to the floor three times within five seconds. The oil light should flash and then go off, indicating it has been reset.
The recommended tire pressure for a 2000 Pontiac Montana is typically 35 PSI for both front and rear tires. However, you should always verify this information in the owner's manual or the tire placard located on the driver's side door jamb.
If your Pontiac Montana won't start, check the battery connections to ensure they're tight and free of corrosion. Verify that the battery is charged. If these are not the issue, inspect the starter and ignition system, and check for any blown fuses.
The 2000 Pontiac Montana typically requires 5W-30 engine oil. It is recommended to use high-quality, API-certified motor oil for best performance and longevity.
To change the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the electrical connector and the retaining clip or screws. Pull out the old bulb and replace it with a new one. Reconnect everything and test the headlight.
Common causes of overheating include a faulty thermostat, low coolant levels, a clogged radiator, or a failing water pump. Inspect these components and replace or repair as necessary to resolve overheating issues.
To replace the serpentine belt, locate the belt tensioner and use a wrench to rotate it, relieving tension on the belt. Remove the old belt and install the new one according to the belt routing diagram. Release the tensioner to secure the new belt in place.
The 2000 Pontiac Montana has a towing capacity of approximately 3,500 pounds when properly equipped. Always refer to the owner's manual for specific towing guidelines and ensure your vehicle is equipped with the necessary towing package.
With the engine warm and idling in park, locate the transmission dipstick under the hood. Pull it out, wipe it clean, reinsert it fully, and then remove it again to check the fluid level. The fluid should be between the "Full" and "Add" marks.
Signs of a failing fuel pump include difficulty starting the vehicle, sputtering at high speeds, loss of power when under load, and unusual whining noises from the fuel tank area. If you experience these symptoms, consider having the fuel pump inspected.