Pontiac Grand Am 2003 Owner's Manual
![Pontiac Grand Am 2003 manual cover](/images/YqvPcqIgdrRofWXRpuDBmBjV/thumbs/thumb175x175.webp)
Turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal to the floor three times within five seconds. The change oil light should flash, indicating that it has been reset.
The 2003 Pontiac Grand Am typically requires 5W-30 engine oil for optimal performance. Ensure to check the owner's manual for any specific requirements.
First, check the ABS fuse in the fuse box. If it's intact, inspect the wheel speed sensors for damage or debris. If the problem persists, a diagnostic scan tool may be necessary to read error codes.
The recommended tire pressure for a 2003 Pontiac Grand Am is typically 30 PSI for both front and rear tires. Refer to the sticker on the driver's side door jamb for precise information.
Open the hood and remove the headlight assembly by unscrewing the retaining bolts. Disconnect the electrical connector, then remove and replace the bulb. Reconnect everything and test the new bulb before reassembling.
Common causes for overheating include a malfunctioning thermostat, a failing water pump, or low coolant levels. Check for leaks in the radiator and hoses, and ensure the cooling fans are operational.
Connect the positive cable to the positive terminal of the dead battery, then to the positive terminal of the good battery. Connect the negative cable to the negative terminal of the good battery, then to a metal ground on the Grand Am. Start the donor vehicle, then attempt to start the Grand Am.
Symptoms include difficulty starting the engine, sputtering at high speeds, loss of power under stress, and an inability to start the car. A diagnostic test can confirm fuel pump issues.
The 2003 Pontiac Grand Am is equipped with a timing chain, which typically does not require regular replacement like a timing belt. However, regular inspections are advised to ensure it's in good condition.
Insert the key into the ignition and turn it to the "ON" position. Press and hold the "LOCK" and "UNLOCK" buttons on the remote simultaneously until the locks cycle, indicating successful programming. Repeat the process for additional remotes.