Pontiac G6 2010 Owner's Manual
![Pontiac G6 2010 manual cover](/images/cqdQbDGNoGFFqOuEIggFqcLs/thumbs/thumb175x175.webp)
To reset the oil life monitor on a 2010 Pontiac G6, turn the ignition to the "ON" position without starting the engine. Press the "INFO" button until "OIL LIFE" is displayed. Hold the "RESET" button for several seconds until the display shows 100%.
The recommended engine oil for a 2010 Pontiac G6 is 5W-30, as it provides optimal performance and protection in various weather conditions. Always check the owner’s manual for confirmation.
To replace the battery in the key fob, use a small flathead screwdriver to carefully pry open the key fob case. Replace the old battery with a new CR2032 battery, ensuring the positive side is facing up. Reassemble the key fob.
The "Check Engine" light can indicate various issues ranging from a loose gas cap to a malfunctioning sensor. Use an OBD-II scanner to retrieve the diagnostic trouble codes (DTCs) for specific guidance on the issue.
Open the hood and locate the headlight assembly. Remove the cover by turning it counterclockwise. Disconnect the electrical connector, then remove the old bulb. Insert the new bulb, reconnect the connector, and secure the cover.
The recommended tire pressure for a 2010 Pontiac G6 is typically 30 PSI for both front and rear tires. Always verify with the tire placard located on the driver’s side door jamb.
To program a new key, insert the existing key into the ignition and turn it to the "ON" position. Wait 10 minutes for the security light to turn off. Repeat this step two more times. Then, insert the new key and turn it to the "ON" position for 10 minutes until the security light turns off.
If the AC is not blowing cold air, check the refrigerant levels as low refrigerant is a common cause. Also, inspect the AC compressor and related fuses. If needed, consult a professional mechanic for a detailed diagnosis.
It is generally recommended to change the spark plugs every 100,000 miles. However, you should refer to your owner's manual for the specific maintenance schedule for your vehicle.
To bleed the brakes, start with the wheel farthest from the master cylinder. Have an assistant press the brake pedal while you open the bleeder valve. Close the valve before the pedal is released. Repeat until no air bubbles are present. Proceed to the next wheel, moving closer to the master cylinder.