Nissan Quest 2015 Quick Reference Guide
![Nissan Quest 2015 manual cover](/images/77ce84fc94e030fba3497aaf/thumbs/thumb175x175.webp)
For a Nissan Quest 2015, it is recommended to use SAE 5W-30 full synthetic oil for optimal performance.
To reset the maintenance light, turn the ignition to the ON position without starting the engine, press the trip button until “Settings” is displayed, then select “Maintenance” and follow the prompts to reset.
A squealing noise at startup may indicate a worn or loose serpentine belt. It is advisable to inspect the belt for wear and tension, and replace if necessary.
The recommended tire pressure for a Nissan Quest 2015 is typically 35 psi for both front and rear tires. Always check the tire placard located on the driver’s door for the most accurate information.
It is recommended to change the air filter every 15,000 to 30,000 miles, or as specified in your vehicle's owner’s manual. More frequent changes may be needed in dusty conditions.
Start by checking the A/C fuse and relay. If they are functional, inspect the refrigerant level and consider issues with the compressor or blower motor. Consulting a professional mechanic may be necessary if the problem persists.
The Nissan Quest 2015 has a towing capacity of up to 3,500 pounds, when properly equipped. Always consult the owner’s manual for specific requirements and limitations.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Disconnect the power connector, remove the rubber boot, twist the bulb counterclockwise, and replace it with a new one.
Poor fuel economy can be caused by under-inflated tires, dirty air filters, or spark plug issues. Regular maintenance and inspections can help improve fuel efficiency.
To program a new key fob, insert the key into the ignition and turn to ACC. Within 5 seconds, insert the key into the ignition and turn to ON, then OFF. Repeat this process 6 times to enter programming mode, then press any button on the new key fob.