Montpellier MDW1054W Installation Instructions

To reset the Montpellier MDW1054W dishwasher, turn off the power using the control panel. Wait for approximately 5 minutes before turning it back on. This allows the system to reset completely.
First, check if the drain hose is kinked or blocked. Make sure the sink's drain is clear. Clean the dishwasher filter and ensure that the pump is not obstructed by debris.
To clean the filter, remove the bottom rack to access the filter at the base. Twist it counterclockwise to remove, rinse it under running water, and scrub gently with a soft brush. Reinstall by twisting clockwise.
Ensure the door is fully closed and latched. Check the power supply and make sure the dishwasher is plugged in. Also, verify that the control panel settings are correct and the delay start option is not activated.
Error code E4 indicates a water leakage or overflow issue. Check for leaks around the dishwasher and ensure the float switch is not stuck. Inspect the door seal for any damage.
It is recommended to run a maintenance cycle with a dishwasher cleaner every 1-2 months. This helps to remove limescale and buildup, keeping the dishwasher running efficiently.
It is best to use detergents formulated specifically for dishwashers. Avoid using dish soap or hand soap as these can cause excessive foaming and potential damage.
Open the rinse aid dispenser located on the inside of the door. Turn the dial to adjust the setting. Higher numbers dispense more rinse aid per cycle, which can help with drying and spotting issues.
The Montpellier MDW1054W can reach temperatures of up to 70°C (158°F) during the hottest cycle, which is typically the intensive or heavy wash cycle.
Ensure the dishwasher is level and secure it to the countertop using the mounting brackets provided. Connect the water inlet and drain hoses, then plug in the power supply. Follow the installation instructions in the user manual for detailed steps.