Miele KF 2802 Vi Operating and Installation Instructions

To change the water filter, locate the filter compartment inside the refrigerator. Turn the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it is securely in place. Run water through the dispenser for a few minutes to clear any air and impurities.
Ensure the refrigerator is plugged in and the door is fully closed. Check the temperature settings and adjust if necessary. Clean the condenser coils located at the back or underneath the refrigerator. If the problem persists, consider calling Miele customer service for further assistance.
It is recommended to clean the condenser coils every six months to ensure optimal efficiency and performance of your Miele KF 2802 Vi Refrigerator.
Yes, the door shelves are adjustable. Simply lift the shelf and move it to the desired position, then lower it into the new slots.
Normal sounds include humming, clicking, or occasional sharp popping noises. These are typically due to the compressor and the refrigerant cycle. However, if you notice loud or unusual sounds, it may require professional inspection.
To improve energy efficiency, ensure the door seals are tight, avoid overloading the refrigerator, and set the temperature to the recommended settings. Additionally, make sure to allow hot food to cool before placing it inside.
First, check if the ice maker is turned on and the water line is connected. Also, confirm that the freezer temperature is set correctly. Examine the ice maker for any visible blockages. If the issue persists, contact Miele support.
To clean the interior, remove all food items and shelves. Use a mild detergent and warm water to wipe down the surfaces. Rinse with clean water and dry thoroughly before replacing the shelves and food items.
Minor condensation is normal, especially in humid environments. However, excessive moisture could indicate a sealing issue or improper temperature settings. Ensure the door is closed properly and the seals are clean and intact.
To reset the temperature alarm, press the alarm button on the control panel. This will silence the alarm and reset the system. Ensure the door is closed properly and the temperature is set correctly.