Mercedes-Benz GLA 2016 Operator's Manual

To reset the tire pressure monitoring system, turn on the ignition without starting the engine. Use the steering wheel controls to navigate to the 'Service' menu on the display. Select 'Tire Pressure' and then 'Reset'. Confirm the reset and drive at a speed above 20 mph for a few minutes to complete the process.
The recommended engine oil for the Mercedes-Benz GLA 2016 is 5W-40 synthetic oil that meets the MB 229.5 specification. Always check your owner’s manual for any specific recommendations.
To connect your smartphone via Bluetooth, enable Bluetooth on your phone. In the GLA’s infotainment system, navigate to 'Telephone' and then 'Connect Device'. Select your phone from the list of available devices and confirm the pairing code.
The recommended maintenance schedule includes service intervals every 10,000 miles or 12 months, whichever comes first. This includes oil changes, brake inspections, fluid level checks, and tire rotations. Refer to your owner’s manual for a detailed schedule.
To replace the air filter, open the hood and locate the air filter housing on the driver’s side. Unclip the housing cover and remove the old filter. Insert the new filter, ensuring it is seated properly, and reattach the housing cover.
If the check engine light comes on, ensure the gas cap is tightly secured as a loose cap can trigger the light. If the light remains on, it’s advisable to have the vehicle diagnosed by a professional mechanic to identify any underlying issues.
To update the navigation system, visit the official Mercedes-Benz website to purchase the latest map update. Follow the instructions to download the update to a USB drive. Insert the USB drive into the vehicle’s USB port and follow the on-screen instructions to complete the update.
To change a flat tire, locate the spare tire, jack, and lug wrench in the trunk. Loosen the lug nuts slightly. Use the jack to lift the vehicle and remove the lug nuts completely. Replace the flat tire with the spare, hand-tighten the lug nuts, lower the vehicle, and then fully tighten the nuts in a criss-cross pattern.
If the battery dies, you can jump-start the vehicle using jumper cables and another car. Connect the cables to the positive and negative terminals of both batteries, ensuring correct polarity. Start the assisting vehicle and then your GLA. Once started, remove the cables in reverse order.
To adjust the headlights, park the vehicle on a level surface facing a wall. Open the hood and locate the adjustment screws on the headlight assembly. Use a screwdriver to adjust the vertical and horizontal aim to achieve the desired headlight alignment.