Mercedes-Benz G-Class 2015 Operator's Manual
![Mercedes-Benz G-Class 2015 manual cover](/images/bccdf2b0a931c23242621c9b/thumbs/thumb175x175.webp)
To reset the tire pressure monitoring system, first ensure all tires are inflated to the recommended pressure. Turn on the ignition without starting the engine, then use the steering wheel controls to navigate to the 'Service' menu. Select 'Tire Pressure' and follow the prompts to reset the system.
The 2015 Mercedes-Benz G-Class typically requires synthetic motor oil with a viscosity rating of 5W-40. Always refer to the owner's manual for the manufacturer's recommendations.
If you notice uneven ride height or a warning light, check for leaks in the air lines and inspect the air compressor. A diagnostic scan tool can help identify fault codes related to the suspension system.
Routine maintenance should be performed every 10,000 miles or 12 months, including oil changes, brake inspections, and fluid level checks. Refer to the owner's manual for a detailed schedule.
To pair your smartphone, activate Bluetooth on your device, then access the 'Telephone' menu on the vehicle's COMAND system. Select 'Connect Device' and follow the on-screen instructions to complete pairing.
Begin by checking if the navigation disc or SD card is properly inserted. If the issue persists, try resetting the COMAND system by holding the power button for 10 seconds. If problems continue, a software update may be necessary.
To replace the battery, remove the mechanical key by pressing the release button. Use the key to pry open the key fob casing, then replace the old battery with a new CR2025 battery, ensuring the positive side faces up.
A squealing noise during braking is often caused by worn brake pads. Inspect the pads for wear and replace them if necessary. If the pads are in good condition, the noise could be due to glazed pads or rotors.
Common issues include air suspension problems, electrical glitches, and engine oil leaks. Regular maintenance and prompt attention to warning lights can help mitigate these issues.
To adjust the headlight beam, locate the adjustment screws near the headlight assembly. Use a Phillips screwdriver to turn the screws and adjust the vertical and horizontal alignment as needed. Consult the owner's manual for specific instructions.